Cub Cadet 2000 Series User Manual
Page 93
Advertising
Electronic Power Steering
87
8.
Inspect the EPS motor gasket. If it is damaged,
replace it.
NOTE: Do not use a gasket sealant/adhesive on the EPS
motor gasket.
9.
Remove the sun gear from the EPS motor.
10. Install the sun gear into the planetary gear set.
11. Install the EPS motor.
NOTE: While installing the EPS motor, align the motor pig
tail with the EPS motor harness.
12. Install the EPS assembly in the tractor by following
the procedures described in the EPS removal sec-
tion of this chapter.
13. Test run the tractor in a safe area before returning it
to service.
Figure 6B.12
Sun gear
Figure 6B.13
EPS motor pig tail
Harness
Advertising