Cub Cadet 2000 Series - Manual (Page 36)

2000 Series Tractors
30
Hood components: pivot bracket removal
1. Remove the hood assembly from the tractor, and
place it on a stable work surface.
2. Remove the four screws, indicated by the arrows in
Figure 4.12, using a 3/8” wrench.
3. Slide the heat shield out of the hood.
4. Remove the two screws that hold the pivot bracket
and grille to the hood assembly using a 1/2” wrench.
See Figure 4.13.
5. Remove the four screws, indicated by the arrows in
Figure 4.14, that hold the outer arms of the pivot
bracket to the hood using a 3/8” wrench.
6. Assemble and install the grille by reversing the
steps used to remove it.
• Tighten the small screws to a torque of 15-35
in-lbs. (1.7-4.0 N-m).
• Tighten the large screws to a torque of 25-45
in-lbs (2.80-5.1 N-m).
Figure 4.12
Figure 4.13
Screws
Figure 4.14