Cub Cadet 2000 Series User Manual
Page 55
Drive
49
7.
While holding the drive control rod up and out of the
way, slide the drive pedal shaft towards the left
enough for the bell crank to clear the pin on the brake
shaft’s bell crank.
8.
Rotate the drive pedal shaft towards the rear of the
tractor enough for the bell crank to clear the brake
pedal shaft’s bell crank.
9.
Remove the drive pedal shaft by sliding it towards the
right enough for it to clear the hole in the frame.
10.
If the reverse switch is mounted on the drive control
rod, disconnect it. See Figure 5.24.
NOTE: The reverse switch was moved to the transmission
for the 2012 model year.
11.
Install the drive pedal shaft by following the previous
steps in reverse order.
12.
Perform a hydro neutral control adjustment by follow-
ing the procedures described in that section of this
chapter.
13.
Test drive the tractor in a safe area before returning it
to service.
Figure 5.24
Reverse switch