Cub Cadet 2000 Series User Manual
Page 92
2000 Series Tractors
86
EPS motor
To remove/replace the EPS motor and test it:
NOTE: The EPS system comes with a 4 year war-
ranty. DO NOT remove the EPS motor to
test it within the warranty period. Outside of
the warranty period, the EPS motor can be
replaced separately from the EPS assembly.
1.
Remove the EPS assembly by following the proce-
dures described in the EPS removal section of this
chapter.
2.
Disconnect the EPS motor harness.
3.
Remove the two screws, indicated by the arrows in
Figure 6B.10, that secure the motor base to the
EPS using a 3/8” wrench.
4.
Lift the motor assembly off of the EPS.
5.
Mount the motor in a vise.
NOTE: Position the motor so that the vise jaws
clamp the motor base, to prevent damage to
the motor.
6.
Attach the black wire from the motor to the negative
side of a 12 volt power supply capable of producing
40 amps.
NOTE: The tractor’s battery or a jumper box can be
used as a power supply.
7.
Attach the red wire from the motor to the positive
side of the power source.
NOTE: The motor should spin. If it does not, replace
the motor.
Figure 6B.10
Figure 6B.11
Red wire
Black wire