Freerider FR510DXs2b(Kensington-S) - Manual (Page 8)

4.
1. Remove your seat from the Scooter by lifting the seat
locking lever and lifting the seat clear of the vehicle (see
Fig 1). Note :your seat can only for safety reasons be
removed when it is Turned 90 to the right or left from
the straight ahead driving position. Please take care
when lifting heavy weights. Place your seat on a soft
clean work area.
2. With the aid of a 17mm spanner (not supplied) loosen
the 10mm seat clamp fixing bolt (see Fig 6).
3. Remove the 10mm fixing bolt and reposition the bolt
into one of the four preferred location holes of the seat
mounting tube (see Fig 6).
4. Re-tighten the 10mm fixing bolt. Refit the seat onto
your Scooter. Do not have the
seat set too high, you must be able to place both feet
firmly on the Scooter's floor area. Stability will be
reduced the higher your seat is set on the mounting
tube. Always take great care when cornering, lean
into the corner to achieve the best stability from your
Scooter.
For a comfortable driving
position the backrest of your seat can be adjusted to
one of the four fixed positions by moving the stop bolt
located in each side hinge bracket(see fig 7).The left
hinge bracket is marked 90 ,100 ,105 and 120 with
corresponding hole positions. With the aid of a 4mm
hexagon key and a9mm spanner(not provided)remove
and reposition the stop bolt from each of the two hinge
brackets, into the appropriate angled position. Retighten
each bolt and locknut making certain the two bolts are
located in exactly the same position on either side.
Both stop bolts must be positioned in the same
position for the backrest to be fully supported, failure to
observe this warning may distort the backrest frame.
The rearward stability of your scooter will be
reduced the greater the backrest is set past 90 .Always
Seat Slide Adjustment:
Freerider
Freerider
5. Seat Height Adjustment:
Freerider
(Fig 4).Located on the right front
side of the seat. This lever allows you to adjust your seat
forwards and backwards when sitting on the seat. Simply
pull up the lever and move in the desired position
backwards by pushing or forward by hitching. As soon as
the lever is released, the seat will lock into the new
position.
Test that the seat has fully locked by hitching
backwards and forwards.
Do not carry out this operation when your
Scooter is moving ,first stop apply the brakes and then
carry out the seat positioning.
The seat as fitted to your Scooter, has a fold
down backrest(see Fig 5).The seat has two height positions.
Your
distributor will position the seat to allow you
the most comfortable driving position.
You may need to alter the seat
height setting at a later date, please follow these
instructions.
6. Backrest Angle Adjustment :
Caution:
Warning:
Warning:
Warning:
SEAT:
Warning:
Seat Slide Adjustment:
Freerider
Freerider
5. Seat Height Adjustment:
Freerider
Caution:
Warning:
Warning:
Warning:
Warning:
SEAT:
6. Backrest Angle Adjustment :
8
FIG 3
FIG 4
FIG 5
FIG 6
FIG 7