Freerider FR510DXs2b(Kensington-S) User Manual
Page 9
9
take great care when going up steep slopes or kerbs,
always lean forward to achieve the best stability for your
Scooter.
The upper cushion of your
backrest (See Fig 8) can be adjustment for height, giving
you more back support if you are tall, by operating the
small latch at the base of the left hand round support bar.
Lift the cushion up or push down for the most comfortable
position. The headrest will also lift out for convenience.
Your Scooter seat is fitted with a
safety belt to prevent you from slipping forwards under
braking conditions or when going sown a slope or over
obstacles, always us it-even for short journeys.
The lap belt can be adjusted on one side to fit
comfortably around your waist. To fit simply connect the
two buckles together( see fig 9 )until a distinct 'click' is
heard. To remove simply 'press' the red buckle and the
two belts will separate.
Care should be taken
when the belt is not in use, it should be connected
together and placed in the centre of the seat cushion.
Failure to observe this notice could lead to the two
buckles falling onto and damaging the bodywork, catching
a person or foreign body.
The handlebar of your Scooter is designed to allow you to
position it in a comfortable driving position. It can be locked
into numerous positions or unlocked to move freely for
transportation.
The handlebar lock is operated by a black lever positioned on
the right hand side of the handlebar (see Fig 10). To release
the handlebar from a locked position pull the black lever
upwards, the handlebar will now move freely, but under mild
tension.
To lock the handlebar into a comfortable driving position,
simply push the black lever downwards until the handlebar is
locked firmly into position.
With the combination of the height adjustment together with
the handlebar movement, you should find a suitably
comfortable driving position.
Always make certain the handlebar locking lever is
fully down and the handlebar is securely clamped onto the
chrome support plates before driving your Scooter. For service
adjustment of this part, refer to the Care and Maintenance
section of this manual.
Your controls are located on the handlebar console (see
Fig11) they are:
This allows you to pre-select
you desired top speed. The dial is proportional to speed
and can be set anywhere between 'min' and 'max' increments.
Turn the dial knob anti-clockwise to minimum for a very
7.
Backrest Height Adjustment:
1.
Speed Adjustment Dial:
Do not drive up a slope greater than 5 if your
backrest is positioned at the 120 position. Failure to
observe this warning may put you in a dangerous situation.
Caution:
8.
Lap Saftery Belt:
HANDLEBAR ADJUSTMENT
Warning:
CONTROL FEATURES
7.
Backrest Height Adjustment:
8.
Lap Saftery Belt:
1.
Speed Adjustment Dial:
Caution:
HANDLEBAR ADJUSTMENT
Warning:
CONTROL FEATURES
FIG 8
FIG 9
FIG 10
On-Off
Power
Switch
5
Battery
Meter
Status
Indicator
Hazzard
WIIarning
Hi/Lo
Speed
Switch
74
6
3
Horn
Direction
Indicator
Light Switch
9
10
2
Front/Rear
Light Switch
FIG 11
Speed
Adjustment
Dial
1
6
Diection
Warning
Lights
Diection
Warning
Lights
7
8
Lo-Speed
Warning
Light