Industrial Data Systems IDS 160 - Manual (Page 12)

2.5.5 PRINT, SUBTOTAL, AND TOTAL.
This feature provides a subtotal and a total register for summing
weighments.
The Print Switch prints the weight on the scale. The printer adds the
weight to the subtotal and total registers.
The Aux Switch prints the subtotal and clears the subtotal register.
Press the Aux Switch again to print the total.
Press the Aux Switch twice within 10 seconds to clear the total
register.
2.5.6 PRINT AND TOTAL ( AXLE WEIGH ).
This feature is for printing a list of weights with the total at the
end.
The Print Switch prints a sequence number and the weight on the scale.
The printer adds the weight to the total register.
The Aux Switch prints the total.
2.5.7 WEIGH-IN, WEIGH-OUT.
This feature allows a truck (container, etc) to weigh-in either empty or
full, and then weigh-out after filling or unloading.
Pressing the PRINT switch stores the weigh-in weighment, and pressing
AUX switch stores the weight-out weighment and causes the GROSS, TARE
and NET weight to be calculated and printed.
2.5.8 AUTOMATIC AXLE WEIGHING.
Automatic axle weighing allows unattended weighing for short scale
platforms. The program will activate TTL outputs for a red and green
traffic light. The automatic axle program uses a combination of a
weight trip level a timing delay to determine axles weights on the
scale.
The trip level is the weight that each axle must exceed to be a valid
axle. You can configure the trip level to be 500, 1000, 2000 or 5000
(default).
The Time out time the amount of time that needs to elapse before
printing the total weight of the axles.
The Settle time is the amount of time that the scale needs for it to
settle.
The TTL outputs for red and green traffic lights are as follows:
Pin 25 -> Green light -> (Open collector output)
Pin 18 -> Red light -> (Pulled up output)
Pin 6 -> -> (5 volt pull up)
This feature allows the operator to start weighing the axles by pressing
the Print Switch. It provides a list of axle weights with the total at
the end.
The Aux Switch allows the operator to force the operation to end and
totalize the axles.