Industrial Data Systems IDS 160 - Manual (Page 18)

3.2.4 CONFIGURATION: BOTTOM MARGIN
.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 2.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 1.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for BOTTOM MARGIN = 0 line feeds.
1 for BOTTOM MARGIN = 2 line feeds.
2 for BOTTOM MARGIN = 4 line feeds.
3 for BOTTOM MARGIN = 6 line feeds.
.
.
.
9 for BOTTOM MARGIN = 18 line feeds.
7. Press the ENTER switch. The ENTER light turns off.
NOTE: The factory setting of the bottom margin is 8 line feeds. This
setting feeds the paper 1 space past the tear bar.
------------------ SET BOTTOM MARGIN -----------------
FLASH ON OFF (Enter Light)
Bottom Margin: OFF 2 1 0 (Thumbwheel Switch)
Bottom Margin: Clear 2 1 4 (Thumbwheel Switch)
Tear Bar (8 line feeds)
REMEMBER: Return the thumbwheel switch to the correct mode position
after configuration