Industrial Data Systems IDS 160 - Manual (Page 20)

3.2.6 CONFIGURATION: STATION NUMBER.
The station number is enabled when it is set. Setting the station
number to 0 disables it.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 2.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 4.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for STATION NUMBER = DISABLED.
1 for STATION NUMBER = 1.
.
.
.
9 for STATION NUMBER = 9.
7. Press the ENTER switch. The ENTER light turns off.
------------------ SET STATION NUMBER -----------------
FLASH ON OFF (Enter Light)
Disable Station No. 2 4 0 (Thumbwheel Switch)
Set Station No. = 1 2 4 1 (Thumbwheel Switch)
. .
. .
Set Station No. = 9 2 4 9 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode position after configuration