Industrial Data Systems IDS 160 - Manual (Page 28)

3.4.1 CONFIGURATION: SCALE METER TYPE.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 7.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 1.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
1 - AN5316, continuous output mode.
2 - Condec, Accuweigh, Applied Forces,
MSI Transweigh, Streeter Q9000.
3 - A&D 4316, 4321, GENERAL 521.
4 - CARDINAL 738.
5 - Toledo 8132, 8142 high speed mode.
6 - Weigh-Tronix WI110, WI120.
7 - DR 10K.
8 - SSD800.
9 - Pulse Input.
7. Press the ENTER switch. The ENTER light turns off.
---------------- SET SCALE METER TYPE -----------------
FLASH ON OFF (Enter Light)
Set AN5316 7 1 1 (Thumbwheel Switch)
Set Condec 7 1 2 (Thumbwheel Switch)
Set A&D / Gen. 7 1 3 (Thumbwheel Switch)
Set Cardinal 738 7 1 4 (Thumbwheel Switch)
Set Toledo 32/42 7 1 5 (Thumbwheel Switch)
Set WI 110 7 1 6 (Thumbwheel Switch)
Set DR 10K 7 1 7 (Thumbwheel Switch)
Set SSD800 7 1 8 (Thumbwheel Switch)
Set Pulse Input 7 1 9 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode position
after configuration