Industrial Data Systems IDS 160 - Manual (Page 33)

3.4.6 CONFIGURE : TIMEOUT TIME
The default setting for the timeout time is 15 seconds.
To set the timeout time to another time do the following:
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 7.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 6.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel to the first digit.
7. Press the ENTER switch. The ENTER light is still on.
8. Turn the thumbwheel to the second digit.
9. Press the ENTER switch. The ENTER light turns off.
------------------ SET TIMEOUT TIME -----------------
FLASH ON ON OFF (Enter Light)
7 6 X X (Thumbwheel Switch)
(XX is a 2 digit timeout time)
Note: You must enter two digits even if you only want a one digit
number. Ex. you want 5 seconds, you must enter 05.
3.4.7 CONFIGURE : SETTLE TIME
The default setting for the settle time is 05 seconds.
To set the settle time to another time do the following:
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 7.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 7.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel to the first digit.
7. Press the ENTER switch. The ENTER light is still on.
8. Turn the thumbwheel to the second digit.
9. Press the ENTER switch. The ENTER light turns off
.
------------------ SET SETTLE TIME -----------------
FLASH ON ON OFF (Enter Light)
7 7 X X (Thumbwheel Switch)
(XX is a 2 digit settle time)
Note : You must enter two digits even if you only want a one digit
number. Ex. you want 5 seconds, you must enter 05.
REMEMBER: Return the thumbwheel switch to the correct mode position
after configuration