Industrial Data Systems IDS 160 - Manual (Page 34)

3.5 INITIALIZE SYSTEM TO FACTORY SETTINGS
The printer can be reset to its original settings by the INITIALIZE
function.
1. Begin with ENTER light OFF
2. Turn the thumbwheel switch to position 8.
3. Press the ENTER switch. The ENTER light flashes.
4. Press the ENTER switch. The ENTER light turns on.
5. Press the ENTER switch one more time
6. The ENTER light turns off.
--------------- INITIALIZE SYSTEM ---------------
FLASH ON ON OFF (ENTER LIGHT)
8 8 8 8 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode position
after configuration