KEYENCE GT2 Series - Manual (Page 2)

2
 Changing the bank (program)
1. Press the up/down arrow button while pressing the MODE button.
2. The bank (program) would be switched to another one. Each bank
(program) will have an own HH/HIGH/LOW/LL/PRESET setting
value.
Function setting mode
 How to enter the Function setting mode
1. Press the MODE button for at least 2 seconds.
2. Press the left/right arrow button and select the function number.
 01 Detection mode
Set the detection mode from [Standard], [NG hold], [Peal hold], [Bottom
hold] or [Peak to peak] mode.
 02 Hold update method
Set how to update the hold value from [Timing input] or [Regular
update].
Only available when
is set to [Standard], [Peal hold] or
[Bottom hold].
 03 Response time
Set the response speed.
 04 Timing type
Set the timing time from [External input], [Rising edge] or [Falling edge].
Only available when
is set to [Standard], [Peal hold] or
[Bottom hold].
 05 Self timing level
Set the self timing level. Only available when is set to
[External input].
 06 Self timing delay type
Set how the value is decided after the self timing is input, from [Static
hold] or [Delay timer].
Only available when
is set to [Standard], and is set
to [External input].
 07 User specified delay time
Set the delay time used for .
Only available when is set to [Delay timer].
 08 Static hold delay stability criterion
Set how the decide the range, which is used to judge if the value is
stable or not, from [Default] or [User].
Only available when is set to [Static hold].
 09 Static hold delay stability width
Set the range which is used to judge if the value is stable or not.
Only available when
is set to [User].
Basic setting mode
 How to enter the Function setting mode
1. Press the MODE and SET button at the same time for at least 2
seconds.
2. Press the left/right arrow button and select the function number.
 10 Measurement direction change
Set how the value moves, when the spindle is pressed, from [Normal]
or [Reverse].
 11 Measurement direction change
Set a number if the value has to be multiplied.
 12 Output format
Set the output mode from [N.O.] or [N.C.].
[MODE] button
Main screen
[MODE]
button
[SET] button
Main screen
While holding
down [MODE],
press the [Up].
While holding down
[MODE], press [Up].
While holding down
[MODE], press [Up].
While holding down
[MODE], press [Up].
<Bank 0 is selected>
<Bank 1 is selected>
<Bank 2 is selected>
<Bank 3 is selected>
The bank indicator is
turned off.
The bank indicator 1
is lit in green.
The bank indicator 2
is lit in green.
The bank indicator 3
is lit in green.