KEYENCE GT2 Series - Manual (Page 3)

3
 13 Displayed number of digits
Set the number of digits of the value.
 14 Hysteresis
Set the hysteresis value.
 15 Batch input setting
Set if the external input to the main unit should work only to the main
amplifier, or also to the sub amplifier.
 16 Special output setting (normal amplifier without analog
output)
Set how to use the special output.
Able to select from [Not used], [5-output], [Limit output], [Limit output
user setting], [All GO] or [All limit output].
 17 Limit output HH side criterion position setting (normal
amplifier without analog output)
Set the HH position for the limit output.
 18 Limit output LL side criterion position setting (normal
amplifier without analog output)
Set the HH position for the limit output.
 16 Analog range setting (analog amplifier)
Set how to set the analog output range from [Default] or [Free range
settings].
 17 Free range settings (Hi) (analog amplifier)
Set the value which will show 20mA.
Only available when is set to [Free range settings].
 18 Free range settings (Lo) (analog amplifier)
Set the value which will show 4mA.
Only available when is set to [Free range settings].
Additional function setting mode
 How to enter the Function setting mode
1. Press the MODE and left arrow button at the same time for at least
2 seconds.
2. Press the left/right arrow button and select the function number.
 20 Select preset data
Select which data the preset should work to, from [R.V. value] or [P.V.
value].
 21 Store preset value
Set if the preset data should be memorized or not.
 22 Preset point
Select if the preset point should be common for all banks or
individual for each bank.
 23 Power save function
Select from [OFF], [ECO Half] or [ECO all].
Main screen
[MODE]
button
Left arrow
button
1114-1