KEYENCE BL-N70 Series - Manual (Page 68)

-14
Ap
pend
ices
A-5
Replacing the Communication Cable
z Removing the communication cable
Procedure
1
Remove the BL-N70 series from the connected computer or controlling device. If the BL-
N70 series uses an AC adapter as the power source, cut off the power supply.
2
Insert one end of a paper clip in the direction of the arrow into the cable release hole on the
back of the BL-N70 series and press down.
3
With the wire pressing into the hole as described in Step
2
, grab the cord connector on the
cable and slowly pull it out.
CAUTION
Do not replace the communication cable while power is being supplied to the
BL-N70 series. Doing so may cause damage or failure in the product.
Make sure that power is not being supplied to the BL-N70 series when replacing
the communication cable.
Cable release hole
Cord protector