AERCO BMK 1.5 LN Dual Fuel Feb 2013 - Manual (Page 31)

CHAPTER 3: CONTROL PANEL OPERATION
PR2: 05/09/12 Page 31 of 162
Benchmark 1.5LN Dual-Fuel Low NOx Boiler
Operation and Maintenance Manual
OMM-0041_0C
GF-121
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 • Ph: 800-526-0288
Table 3-1 Operating Controls, Indicators and Displays
ITEM
NO.
CONTROL,
INDICATOR OR
DISPLAY
FUNCTION
1 LED Status
Indicators
Four Status LEDs indicate the current operating status as follows:
COMM Lights when RS-232 communication is occurring
MANUAL Lights when the unit is being controlled using the front panel
keypad.
REMOTE Lights when the unit is being controlled by an external signal from
an Energy Management System
DEMAND Lights when there is a demand for heat.
2 OUTLET
TEMPERATURE
Display
3–Digit, 7–Segment LED display continuously displays the outlet
water temperature. The °F or °C LED next to the display lights to
indicate whether the displayed temperature is in degrees
Fahrenheit or degrees Celsius. The °F or °C blinks when operating
in the Deadband Mode.
3 VFD Display Vacuum Fluorescent Display (VFD) consists of 2 lines each
capable of displaying up to 16 alphanumeric characters. The
information displayed includes:
Startup Messages
Fault Messages
Operating Status Messages
Menu Selection
4 RS-232 Port Port permits a Laptop Computer or External Modem to be
connected to the unit’s Control Panel.
5 FAULT Indicator Red FAULT LED indicator lights when a boiler alarm condition
occurs. An alarm message will appear in the VFD.
6 CLEAR Key Turns off the FAULT indicator and clears the alarm message if the
alarm is no longer valid. Lockout type alarms will be latched and
cannot be cleared by simply pressing this key. Troubleshooting
may be required to clear these types of alarms.
7 READY Indicator
Lights ON/OFF switch is set to ON and all Pre-Purge conditions
have been satisfied.
8 ON/OFF Switch Enables and disables boiler operation.
9 LOW WATER
LEVEL
TEST/RESET
Switches
Allows operator to test operation of the water level monitor.
Pressing
TEST opens the water level probe circuit and simulates a
Low Water Level alarm.
Pressing
RESET resets the water level monitor circuit.
Pressing the CLEAR key (item 6) resets the display.