CAMCORP HVP with Duroflow Blower User Manual
Page 4
CAMCORP, INC.
Phone: 913-831-0740 Fax: 913-831-9271
*** SAFETY INFORMATION ***
WARNING!!! - Do not attempt to operate or maintain this piece of equipment until you
have read and understand all of the safety information included in the manual. This piece
of equipment contains moving which can cause serious injury. If you do not understand
anything in this manual seek assistance prior to operations.
LOCKOUT-TAGOUT REQUIREMENTS – Before installation, inspection, or
servicing this equipment perform an approved lockout-tagout procedure on the electrical
service, air supplies, or any other energy source. Refer to OSHA Standard 1910.147 for
guidelines.
SAFETY PRECAUTIONS – Do not operate, inspector, or service this equipment unless
all the following safety precautions are in effect:
•
Guards, access doors, and covers are in place and secure.
•
The equipment has been wired and grounded in accordance with all
applicable codes.
•
An approved lockout-tagout procedure has been followed before the
equipment is inspected, disassembled, and/or serviced. The equipment is
automatically controlled and may start without warning unless energy
supplies are properly disconnected and locked out/tagged out.
•
The control panel enclosure is closed and secured except as is necessary
for service or adjustment.
•
The service door is closed and secured. Do not enter filter while the
system exhaust fan is operating. The airflow can pull service door closed
and trap personnel inside.
•
A confined space permit, if required by authorities has jurisdiction, as
been obtained prior to personnel entering the unit. Check with your
company’s safety director for special instructions, testing prior to entry,
etc. that may be required by the specific application.
RESPONSIBILITY – It is the owner’s responsibility to maintain the safety features
included with this equipment. The safety features may include, but not necessarily be
limited to: guards, access doors and covers, explosions vents, warning decals, cautions
decals, and advisory decals. Replacement safety features are available from the
following:
CAMCORP Inc.
9732 Pflumm Road
Lenexa, KS 66214
Phone: 913-831-0740
Fax: 913-831-9271
Web site: www.camcorpinc.com
2-1