0 pwb layout, jumpers, and terminal connections, 1 control/driver board for q2-2035 through q2-2330, Pwb layout, jumpers, and terminai connections -1 – Toshiba Q-Flowsaver II User Manual
Page 19: Toshiba
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
5.0
PWB Layout, Jumpers, and Terminal Connections
5.1
Control/Driver Board for Q2-2035 through Q2-2330
The following pictorial shows a layout of the major components located on the
control/dhver board VF3B-0100.
Note:
1)
Potentiometer
RH1
is used for control power supply stabilization. This adjustment is
factory set and any
ADJUSTMENT BY THE USER SHOULD NOT BE ATTEMPTED.
2)
Potentiometer
RH2
is used for voltage detection level bias. This adjustment is factory
set and any
ADJUSTMENT BY THE USER SHOULD NOT BE ATTEMPTED.
3)
CPI, CP2,and CP3 are service testpoints.
4)
Do not adjust JP3 and JP10.
5)
Charge LED indicates charged capacitors.
DO NOT TOUCH internal parts if lighted.
5 - 1