Toshiba, 5 output terminal status code – Toshiba Q-Flowsaver II User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
8.5
Output Terminal Status Code
The table below shows the status codes of the open collector transistor outputs.
RCH(UL) and LOW(LL) are multi-functional terminals. The correct terminal output
representation is determined by setting the Output Selection function [:0.tb]. Refer to
Item 6 on page 7-3 and Terminal Block details on page 5-5. If output terminal select
[:0.tb]=2 then terminal RCH(UL)=RCH and terminal LOW(LL)=LL. A reading such as
the example below indicates that terminals RCH and LL are "on" (collector shorted to
ground).
RCH:
Output frequency is within the set reach frequency range or acc/dec is complete.
LOW:
Output frequency is equal to or greater than low speed frequency.
UL:
Output frequency has reached the upper limit frequency (UL).
LL:
Output frequency is equal to or greater than the lower limit frequency (LL).
8 - 5