Toshiba – Toshiba Q-Flowsaver II User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
9.6
SPEED GROUP PARAMETERS
AC LINE/INVERTER TRANSFER SIGNAL (ITEM 1) - Use this function to setup the
inverter to allow a motor load to be transferred between the inverter and the AC line
power by a signal to the inverter.
This is used oniy when the "Muiti-Functionai
Option Board is instaiied.
MULTISPEED RUN FREQUENCY #1 (ITEM 2) - Use this function to set up 1st of 7
preset speed frequencies SRI.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
MULTISPEED RUN FREQUENCY #2 (ITEM 3) - Use this function to set up 2nd of 7
preset speed frequencies SR2.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
MULTISPEED RUN FREQUENCY #3 (ITEM 4) - Use this function to set up 3rd of 7
preset speed frequencies SR3.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
MULTISPEED RUN FREQUENCY #4 (ITEM 5) - Use this function to set up 4th of 7
preset speed frequencies SR4.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
MULTISPEED RUN FREQUENCY #5 (ITEM 6) - Use this function to set up 5th of 7
preset speed frequencies SR5.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
MULTISPEED RUN FREQUENCY #6 (ITEM 7) - Use this function to set up 6th of 7
preset speed frequencies SR6.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
FIRESPEED OVERRIDE FREQUENCY (ITEM 8) - Use this function to set up 7th of 7
preset speed frequencies SR7.
This frequency is run by input terminai connections.
See Input Terminal Operations Page 10-1.
9 - 9