EVCO EVB1256N9 - Manual (Page 32)

EVCO S.p.A. EVBOX1 | Installation guide ver. 1.2 | Code 144BOX1E124
page 32 of 88
dur the display is about to show the alarm duration
h01 the alarm lasted for 1 hour (continue...)
n15 the alarm lasted 1 hour and 15 min
code the alarm selected
the displays each piece of information for 1 s.
To exit the information sequence:
7. Press and release the “ON/STAND-BY”: the display
will show the alarm selected.
To exit the procedure:
8. Exit the information sequence.
9. Press and release the “UP” or “DOWN” key until
the display shows the magnitude established with
parameter P5 or do not operate for 60 sec.
Alternatively:
10. Press and release the “ON/STAND-BY” key.
10.3 Cancelling the HACCP alarm list
To cancel the HACCP alarm list proceed as follows:
1. Make sure that the keyboard is not locked and that
no procedure is in progress.
2. Hold the key “DOWN” for 1 s: the display will show
the first label available.
3. Press and release the "UP" or "DOWN" key to
select “rLS”.
4. Press and release the “SET” key.
5. Press and release the “UP” or “DOWN” key within
15 s to set “149”.
6. Press and release the “SET” or do not operate for
15 sec: the display will show a flashing “- - -” for 4
sec and the “HACCP” LED switches off, after which
the device will exit the procedure.
If the device does not have any alarms stored, the label “rLS”
will not be displayed.
Access the procedure to cancel information on the HACCP alarms
Cancelling information on the HACCP alarms