EVCO EVB1256N9 - Manual (Page 36)

EVCO S.p.A. EVBOX1 | Installation guide ver. 1.2 | Code 144BOX1E124
page 36 of 88
15. Press and release the key or the key within
15 sec to set:
- “Mon” (Monday)
- “tuE” (Tuesday)
- “UEd” (Wednesday)
- “thu” (Thursday)
- “Fri” (Friday)
- “SAt” (Saturday)
- “Sun” (Sunday).
16. Press and release the “SET”: the "clock" LED shall
turn off, and then the device shall exit the
procedure.
To exit the procedure before the operation is complete:
17. Do not operate for 60 sec (any changes will be
saved).
12.2 Setting the working set point
To set the working set point, proceed as follows:
1. Make sure that the keyboard is not locked and that
no procedure is in progress.
2. Press and release the “SET” key: the “compressor”
LED will flash.
3. Press and release the “UP” or “DOWN” key within
15 sec; see also parameters r1, r2 and r3.
4. Press and release the “SET” key or do not operate
for 15 sec: the “compressor” LED will switch off
after which, the device will exit the procedure.
To exit the procedure before the operation is complete:
5. Do not operate for 15 sec (any changes will be
saved).
The working set point can also be set via parameter SP.
12.3 Setting the configuration
parameters
To access the procedure:
1. Make sure no procedures are in progress.
2. Hold the “UP” and “DOWN” key for 4 s: the display
will show “PA”.
3. Press and release the “SET” key.
4. Press and release the “UP” or “DOWN” key within
15 s to set “-19”.
5. Press and release the “SET” key and do not
operate for 15 s.
6. Hold the “UP” and “DOWN” key for 4 s: the display
will show “SP”.
Setting the working set point
Access the procedure to set the configuration parameters