FingerTec H2i Installation Guide - Manual

Back Plate
4 feet / 1.2 meter
(recommended)
H2i
s u p p o r t @ f i n g e r t e c . c o m
H2i s u p p o r t @ f i n g e r t e c . c o m
Back of Terminal
For
NC or
NO
door
lock
system
GND
BUT
SEN
NO
COM
NC
ACCESS
CONNECTIONPORT
DC12V
Power Supply
+12V
GND
POWER SUPPLYPORT
RS485
CONNECTION PORT
1. Single Connection
2. Network Connection
+12V
IWD1
IWD0
RLED
GLED
BEEP
GND
WIEGAND
INPUT
CONNECTION
PORT
3rd party
controller
with 26 bits
wiegand
output
WIEGAND
OUTPUT
CONNECTION
PORT
WD0
WD1
TCP/IP PORT
(Ethernet Connection) -
TCP/IP
485A
485B
485A
485B
485A
485B
RX+
RX-
RS485 Data Converter
RX+
RX-
RS485 Data Converter
3rd party
controller
with 26 bits
wiegand
output
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals on A Wall
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to hang the back plate.
Refer to Appendix II for dimensions and measurements of instal-
lation.
Installation Guides
We Make Things Easy
w w w . f i n g e r t e c . c o m
H2i
Door Access & Time Attendance System
Step 3
Wiring for Power Supply
The power input ports for these models are located at the rear of
the terminals. There is no adapter plug supplied with the models,
instead you need to source for power cable (red and black cables)
to connect the power from the terminal to the AdapTec.