FingerTec TA100C Installation Guide User Manual

Installation guide, Step 2 mounting of terminals, Ta100c series

Advertising
background image

Back Plate

4 feet / 1.2 meter

(recommended)

Res

et

TCP/IP PORT

POWER PORT

USB PORT

........

......

Step 1

Determine the Location and Positioning

of the Installation

Avoid installing the terminals in locations that has contact with

a strong light source (e.g direct sunlight, spotlight, fluorescent

light, etc)

Avoid installing the terminals in locations with high moisture or

condensation levels in the air

The recommended installation height of the terminal from the

ground is 1.2 meter.

Step 2

Mounting of Terminals

A. Mount on WAll

After determining the height of the terminal from the ground level

and have made the relevant marks on the wall, drill the screws into

the wall to secure the back plate.

Attach the terminal to the back plate and tighten the screws. Refer

to Appendix I for dimensions and measurements of installation.

Installation Guide

TA100C Series

Fingerprint Color Multimedia for

Time Attendance System

b. Flexi- Kit

FingerTec offers flexi-kit for all its time attendance models. Attach

the terminal on the flexi-kit for convenience.

Step 3

Wiring for Power Supply

The power jack is positioned on top of the terminal, labeled

Power Adapter Port in the below diagram.

Please use the power adaptor provided in the package or alterna-

tively you can opt for a linear power supply with specifications of

5VDC 2A. Plug the one point of the power adapter to the terminal

and the other end to the power outlet. Don’t exceed the recom-

mended voltage or current to avoid damaging the terminal.

Step 4

Setting Up Data Communications

(Skip this step if you are using USB flash disk to transfer data)

TCP/IP – LAN Connection

For TCP/IP connection, plug the special RJ45 jack into the TCP/IP

(LAN) Port of the terminal. Connect the other end (normal RJ45

jack) to the local area network hub or a PC. Configure the device ID,

IP address, subnet mask and Gateway in the terminal (refer to the

hardware user manual for details).

© 2014 Timetec Computing Sdn Bhd. All rights reserved.• 092014

Advertising