FingerTec i-Kiosk 100 Installation Guide User Manual

Installation guide, Step 2 mounting of terminals on a wall, I-kiosk 100

Advertising
background image

Back Plate

4 feet / 1.2 meter

(recommended)

Wiegand OUT

RS232

RS232

cable

RS485

485B

485A

GND

TXD

RXD

GND

WD1

WD2

3rd party controller

with 26 bits wiegand

input

3rd party

controller with

26 bit swiegand

output

Wiegand IN

BEL+

BEL-

BEEP

GLED

RLED

INWD0

INWD1

GND

+12V

DC12V 3A

Power

Supply

* Use either power input

RX+

RX-

RS232/RS485

Data Converter

485B

485A

1. RS485 Single Connection

RX+

RX-

RS232/RS485

Data

Converter

485B

485A

485B

485A

2. RS485 Network Connection

TC

P

/

IP

RJ-6

RJ-3

RJ-2

RJ-1

TCP/IP

USB Port

Door Lock connector.

Refer to Appendix I

Step 1

Determine the Location and Positioning

of the Installation

Avoid installing the terminals in locations that has contact with

a strong light source (e.g direct sunlight, spotlight, fluorescent

light, etc)

Avoid installing the terminals in locations with high moisture or

condensation levels in the air

The recommended installation height of the terminal from the

ground is 1.2 meter.

Step 2

Mounting of Terminals on a Wall

After determining the height of the terminal from the ground

level and have made the relevant marks on the wall, drill the

screws into the wall to hang the back plate.

Refer to Appendix II for dimensions and measurements of instal-

lation.

Installation Guide

We Make Things Easy

w w w . f i n g e r t e c . c o m

i-Kiosk 100

Fingerprint Color Multimedia for Time Attendance &

Door Access Control System

Step 3

Wiring for Power Supply

There are two ways to connect to the power.
1. Use the power adapter provided in the package and insert the

power adapter to the port marked A in the diagram.

2. Use power cables (black and red) to connect to a linear power

supply with specifications of 12VDC 3A.

Advertising