FingerTec Face ID 3 Installation Guide - Manual

Back Plate
4 feet / 1.2 meter
(recommended)
Wiegand OUT
RS232
RS232
cable
RS485
3rd party controller
with 26 bits wiegand
input
1. RS485 Single Connection
2. RS485 Network Connection
485+
485-
POWER
SUPPLY (A)
Door Lock connector. Refer to Appendix I
suppor t@finger tec.com
3
suppor t@finger tec.com
3
RS232/RS485 SERIAL PORT
485+
485-
485+
485-
TCP/IP PORT
RJ45-1
RJ45-2
RJ45-3
RJ45-6
3rd party
controller
with 26 bit
wiegand output
TCP/IP
GND
+12V
DC12V 3A
Power Supply
BEEP
GLED
RLED
INWD0
INWD1
GND
+12V
485-
485+
GND
TXD
RXD
GND
WD1
WD2
RS232/RS485
Data Converter
RX+
RX-
RS232/RS485
Data Converter
RX+
RX-
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meters.
Step 2
Mounting of Terminals on a Wall
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to fix the back plate.
Refer to Appendix II for dimensions and measurements of instal-
lation.
Installation Guide
w w w . f i n g e r t e c . c o m
Face ID3
Face Recognition System for Door Access
INSTALLATION TIPS:
A good installation location of Face ID
3 must
1 - Avoid sunlight.
2 - 2 meters away from any light source
e.g. ceiling direct flourescent light
3 - Suggested 1.2m from the ground level
(measure from ground to the camera)
Step 3
Wiring for Power Supply
Use power cables (black and red) to connect to a linear power sup-
ply with specifications of 12VDC 3A (Marked A).