FingerTec AC900 Installation Guide - Manual

GND
PWR
COM
NO
NC
GND
AL+
AL-
BUT
GND
B+
B-
GND
RX
TX
GND
485A
485B
GND
D0
D1
+5V
SEN
GND
RS232 Cable
TCP/IP Port (LAN)
GND
RX
TX
+12V 0
Power
Supply
WelcomeCheck-In
01-01 09:00 Fri
Back Plate
4 feet / 1.2 meter
(recommended)
485A
485B
RX+
RX-
1. RS485 Single Connection
RS232/ RS485
Data Converter
485A
485B RX+
RX- 485A
485B
2. RS485 Network Connection
RS232/ RS485
Data Converter
Door Access
Cortrol Port
refer to
Appendix II
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals on A Wall
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, based on
the measurements in Appendix II, drill the screws into the wall to
hang the terminals.
Installation Guide
We Make Things Easy
w w w . f i n g e r t e c . c o m
AC900
Fingerprint Door Access &
Time Attendance System
Step 3
Wiring for Power Supply
The power input port for AC900 is located at the rear of the ter-
minal. There is no adapter plug supplied with AC900, instead you
need to source for power cable (red and black cables) to connect
AC900 and AdapTec.