GTCO DrawingBoard VI - Users Guide - Manual (Page 10)

DrawingBoard VI 10
USB Connection
DrawingBoard VI USB port connection is USB 1.1 and 2.0 compatible. When the digitizer is
connected to the USB port, Windows will recognize that there is a new device connected. If
Windows displays the Found New Hardware prompt, follow the onscreen instructions to
complete the driver installation.
1. Connect the interface cable to the USB jack on the DrawingBoard VI Connector
Panel. The connector is keyed and will fit only the correct jack. Do not force it.
2. Attach the other end of the USB cable to any one of the USB ports on your
computer or USB hub. Turn the power switch on. The digitizer will beep once,
indicating it has power.