GTCO DrawingBoard VI - Users Guide - Manual (Page 13)

DrawingBoard VI 13
3 Save and 3 Restore Keys
The Save and Restore keys work hand-in-hand. They are used to save, or recall/restore, a
setup to or from one of three Save Areas. The tablet comes with three pre-programmed
setups. You can use these setups directly or overwrite them with your own. The Default
Save Key controls the first Save Area. The setup saved to this area is activated whenever
you power-up the digitizer. We recommend you save the setup you use most often as
Default.
Selecting a Pre-Programmed Setup
There are three pre-programmed setups available with DrawingBoard VI:
 GTCO CalComp by Turning Technologies DP5 High Resolution Binary
 Summagraphics MM 1201
 CalComp 2000 ASCII
These setups are commonly used within software applications as required tablet formats.
They are stored in Save Areas Default, 2 and 3, respectively. Check the manual that came
with your software package to see if your application requires one of these pre-
programmed setups. The Default setup is available when you power on the digitizer.
To select one of the other setups:
1. Turn on Configuration Mode by clicking on the Config/Exit key.
2. Click on the desired Restore key.
3. Click on the Config/Exit key again to exit Configuration Mode. The new
setup is activated.