GTCO DrawingBoard VI - Users Guide - Manual (Page 8)

DrawingBoard VI 8
Preparing the Large Format DrawingBoard VI
Mounting on the Stand
Place DrawingBoard VI on a table, desk or drafting table or mount it on a stand or pedestal.
The tablet’s Universal Mounting Brackets attach directly to those stands that have tilt arms.
(The old style stands with tilt pads require right-angle mounting brackets, which are
attached to the tilt pads. The tablet’s Universal Mounting Brackets are then attached to the
right-angle mounting brackets.)
Center the tablet over the attached Universal Mounting Brackets and screw the
Thumbscrews into the T-Nuts in the mounting channel in the tablet’s frame.
Attaching the Optional Accessory Tray or the Optional Plan Holder
Additional T-Nuts have been included in the perimeter mounting channels on the
DrawingBoard VI frame. You can position the Plan Holder or Accessory Tray (see Parts and
Accessories) where it is most convenient for you by attaching it to any one of the available
T-Nuts. The following instructions and the graphic below detail the installation of the
Accessory Tray.
Simply slide the Tray Rails into the channel and line up the hole in the tray with the hole in
the T-Nut. Tighten the Thumb Screw to secure the Accessory Tray.