GTCO CR 1212 - Users Guide - Manual (Page 17)

CR 1212 17
A report issued when the stylus/cursor is out-of-prox is always the last in-prox scanned
report. Because the last scanned report may or may not be the last issued report, their
values could be different. You may find this occurring when collecting reports at very slow
rates.
Point Mode
In Point Mode, the graphics tablet issues one report when pressing a stylus/cursor button
and another when releasing it. (The tip of the stylus is its “button”.) If the stylus/cursor is
moved between the time the button is pressed and time it’s released, the reports will be
different. If the stylus/cursor is out-of-prox, the tablet issues the last in-prox scanned
report.
Remote Request Mode
In Remote Request Mode, the tablet issues one report each time the host sends a trigger
command. Issue the mode command once. Thereafter, send only a trigger command for
each report. After initiating Remote Request Mode, the tablet issues the report resulting
from the first trigger within two milliseconds. The tablet can issue subsequent reports up
to 110 rps (reports per second).
When the stylus/cursor is out-of-prox, the tablet issues the last in-prox scanned report
each time it receives a trigger.