GTCO CR 1212 - Users Guide - Manual (Page 27)

CR 1212 27
Section C: Other Functions
Bit Pad Configuration
If the unit’s hardware configuration is Bit Pad, you can adjust between Bit Pad One and Bit
Pad Two using the commands. (Changing to or from the CR configuration requires a
hardware modification.) Once the configuration is revised; to return to the default, either
send the appropriate command or repower the tablet. The Reset command does not
control the configuration setting.
Origin
Use the Origin command to define the location of the tablet’s origin (0, 0). It can be the
lower or upper left corner of the active area. The default is the lower left.
When the origin is in the upper left corner, Y coordinates are positive, not negative. This
departure from the standard Cartesian coordinate system is to aid in the compatibility
between the CR 1212 and terminals with a screen origin in the upper left corner.