GTCO CR 1212 - Users Guide User Manual

Page 19

Advertising
background image

CR 1212 19


Report Rate

The Report Rate function is an adjunct to Stream and Switch Stream modes. Use Report
Rate to define the number of reports the tablet issues each second. Each time the tablet is
turned on or issues a Reset command, the report rate defaults to 110 or 72 rps, depending
on the hardware configuration.

By their very nature, low baud rates limit the report rate. Therefore, follow these
recommendations:

No higher than 36 rps, when using 2400 baud

No higher than 18 rps, when using 1200 baud

Increment Mode

Command Sequence: <mode command><increment value>

Increment mode is an adjunct to Point, Remote Request, Stream and Switch Stream modes.
(It is particularly useful for reducing data output.) In Increment Mode, the unit sends a
report only when the stylus/cursor has traveled a minimum distance in the X or Y direction.
This minimum distance is the increment. It applies to both axes and is measured in counts
(of resolution).

Advertising