HONDA 2004 CR-V - Owner's Manual - Manual (Page 214)

Remove the power steering
reservoir from the bracket. Pull it
away from the grounding strap. Connect the second jumper cable
to the negative (
) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
Start your vehicle. If the starter
motor still operates slowly, check
the jumper cable connections to
make sure they have good metal-
to-metal contact.
Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then from the booster battery.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until all are
disconnected. Otherwise, you may
cause an electrical short.
Reinstall the power steering
reservoir.
4. 5.
6.
7.
8.
9.
Jump Starting
Taking Care of the Unexpected 210
BRACKET
Main Menu Table of Contents