Juniper Systems LandMark CE - Manual (Page 51)

LandMark CE User’s Manual 51
When New is tapped, a pop-up screen appears.
Change the Waypoint ID and fi ll in latitude, longitude, and
elevation. The units format depends on what is selected in the
confi gurations screen. (See Confi guration instruction to change Units
format.)
Waypoint #
Waypoint # is the number assigned by LandMark CE. All points in a
waypoint fi le are numbered consecutively.
Waypoint ID
Waypoint ID is the point name that you give to a point.
Latitude
Latitude shows a waypoint latitude.
Longitude
Longitude shows a waypoint longitude.
Elevation
Elevation shows a waypoint elevation.
When you are fi nished entering all fi elds, tap on the OK button to go
back to the Waypoint screen. All of your point information is saved
into the waypoint fi le when you tap on OK.
Edit
Tap Edit to edit the selected waypoint. When Edit is selected,
the Waypoint pop-up screen is displayed. The exact format of
the waypoint screen depends on the Units format selected. (See
Confi gurations instructions to change Units format.)
▲