KGUARD Security SHA116.V2 - Manual (Page 17)

ENGLISH
Chapter 2: Installation
DVR User’s Manual
17
Chapter 2: Installation
2.1 Installing the Hard Disk Drive
Depending on the package you have purchased, the hard disk drive may be included in the full package. If it is not
pre-installed, follow the installation instructions on this user manual.
DO NOT install or remove hard disk drive while the device power is turned on.
2.1.1 Installing HDD on 4-Channel / 8-Channel DVR
The 4-channel / 8-channel DVR supports one 3.5” SATA hard disk drive. To install the HDD, follow the steps below.
Note:
The illustrations below show an 8-channel DVR, same procedures apply to a 4-channel DVR.
1
Loosen the screws in the left, right, and rear sides as
shown.
2
Push back then lift up the cover to remove it.
3
Connect the data and power cables to the hard disk
drive (HDD).
4
Attach the HDD to the bracket using 2 screws.
5
Attach the cover and the screws back in place.