KGUARD Security SHA116.V2 - Manual (Page 81)

ENGLISH
Chapter 5: KGuard Web Client
DVR User’s Manual
81
PTZ Setup
When a PTZ camera is installed, use the PTZ Setup menu to customize its settings.
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Device > PTZ Setup. The PTZ Setup screen appears.
3
On Channel, select the channel where the PTZ camera is installed.
3
Set the PTZ control Protocol, Address, Baud Rate, Data Bits, and Stop Bits.
Note:
Check the PTZ camera specifications for the correct settings.
4
Enable or disable Cruise and select a Verify option (None/Odd/Even/Mark/Space).
5
To save, click Apply at the bottom of the screen.
« TIP »
• To apply the same settings to other channels with PTZ camera, click Copy To at the bottom of the screen. See
“Copying Settings To Other Channels” on page 60 .
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications and retain the existing settings, click Refresh at the bottom of the screen.
Mobile Devices Setup
The DVR provides remote access using your mobile phone or a tablet PC. See the “DVR SHA Series Support Manual” in
the enclosed CD for the list of supported mobile devices.
Before using this feature, take note of the following:
• Make sure the DVR is connected to the Internet.
• If the DVR is connected to the Internet through a router, you must forward the port on the virtual server option
of your router. See your router user’s manual for this configuration. Or, use the port forwarding option described
in
“4.2.4 Port Forwarding” on page 44 .
To configure mobile device setup, do the following:
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Device > Mobile. The Mobile screen appears.