KGUARD Security SHA116.V2 - Manual (Page 80)

ENGLISH
Chapter 5: KGuard Web Client
80
DVR User’s Manual
5
On Host Name, enter the domain name.
6
Enter the User Name and Password.
7
Click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications and retain the existing settings, click Refresh at the bottom of the screen.
5.5.6 Setting the Device
Use the Device menu to you can view the hard disk information and setup PTZ, mobile access, and motion detection.
Storage Device Setup
You can remotely view the hard disk information and select an overwrite option. To do this, perform the following:
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Device. The H.D.D. Status screen appears. The information about the installed hard disk(s) on
the DVR are shown.
3
To select an overwrite option, select the hard disk drive from the table (if more than one is installed).
4
On Overwrite, select an overwrite interval option (Close/Auto/1 Hour/3 Hours/1 Day/7 Days/30 Days/90 Days).
Note:
If Overwrite is set to Close, the recording will stop once the hard disk drive is full.
5
To save, click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications and retain the existing settings, click Refresh at the bottom of the screen.