KGUARD Security SHA116.V2 - Manual (Page 76)

ENGLISH
Chapter 5: KGuard Web Client
76
DVR User’s Manual
5.5.3 Setting the Alarm
Use the Alarm menu to select when to trigger the alarm and choose the alarm notification, such as buzzer sound,
email, or full screen notification.
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Alarm.
3
Modify the necessary settings.
Menu item Description
Channel Select the channel that you want to set the alarm.
I/O Status Select YES if an I/O alarm device is connected.
Buzzer
Duration Set the buzzer duration when motion is detected (Off/10 S/20 S/40 S/60 S).
To disable buzzer, select Off. Check to apply the setting to each alarm type.
Alarm Out
Time Select the alarm sound duration of the I/O alarm device (10S/20S/40S/60S) then check to
apply the setting to each alarm type.
Email Select to enable email alarm notification. When enabled, the system sends alarm images
to the specified email address. See
“5.5.4 Setting the Email Notification” on page 77 .
Full Screen Select to enable screen notification. When this function is enabled and the alarm is
triggered, the corresponding channel is displayed in full screen.
MD Alarm Select to enable motion detection alarm. When an object moves into the motion
detection area, the alarm is triggered. To set the motion detection area, see
“Motion
Detection Setup” on page 82 .
I/O Alarm Select to activate the I/O alarm device when the alarm is triggered.
HDD Loss Select to enable HDD loss alarm. When the hard disk drive is not detected due to HDD
damage or the power supply malfunctions, or the HDD auto-overwrite is off, the alarm is
triggered and the
H
icon is displayed on the screen.
HDD Space Select to enable HDD space alarm. When the hard disk drive is full, the alarm is
triggered.
Video Loss Select to enable Video loss alarm. When the DVR cannot receive the video input signal
due to camera damage, cable damage, or the power supply malfunctions, the alarm is
triggered and “Video Loss” is displayed on the screen.
Post
Recording
Select the post recording time after the alarm ends. (30S/1 Min/2 Min/5 Min).
Pre-record
time
Enable/Disable pre-recording before the alarm is triggered.