KGUARD Security SHA116.V2 - Manual (Page 53)

ENGLISH
Chapter 4: Using the DVR
DVR User’s Manual
53
Email Alarm Notifications
To set up an email for alarm notifications, do the following:
1
In preview mode, right-click on the mouse to display the Pop-up menu.
Be sure that the DVR network connection is properly configured before proceeding with the email setup.
2
Select Main Menu > DEVICE > ALARM.
3
Check the E-mail check box and click E-mail Setup.
4
On SSL, check Enable check box if your email server needs the SSL verification. Check with your email service
provider for the applicable setting.
5
Enter the SMTP port and SMTP Server of the sending email server, the email address and password of the sender in
Sender and Sender PWD respectively.
Note:
By default, the SMTP port is 25 for email without SSL verification. For Gmail server or for email that needs SSL
verification, the SMTP port is 465, by default. Check with your ISP for the correct setting.
6
In Receiver, enter the email address where the email alarm is to be sent. In Interval, select an email sending interval.
7
After all settings are complete, click Apply.
8
When data saving is complete, click OK.
Note:
When email setup is complete, click Test to check if your email settings are properly configured.
4.4.3 PTZ Setup
After the PTZ speed dome is properly installed via RS-485 connection, you can customize its settings using the PTZ
SETUP menu.
To set up the PTZ camera setting, do the following:
1
In preview mode, right-click on the mouse to display the Pop-up menu.
2
Select Main Menu > DEVICE > PTZ.
3
Select the channel which the PTZ camera is connected to.
4
Set the PTZ Protocol, Baud Rate, Data BIT, Stop BIT, Parity, Address code.
4
Enable or disable Cruise mode.