KGUARD Security SHA116.V2 - Manual (Page 36)

ENGLISH
Chapter 3: Getting Started
36
DVR User’s Manual
3.5 Using PTZ Controls
If you are using the PTZ speed dome, you can configure the PTZ control settings.
1
In the preview mode, right-click on the mouse to display the Pop-up menu.
2
Select PTZ.
Note:
This option is not available if the PTZ camera is in Cruise mode.
See
“3.5.1 Cruise Mode” on page 37 .
3
The PTZ control panel appears on the screen.
Icon Item Function
Pointer pan Click the direction arrow to select the
direction of the PTZ camera.
Click the middle icon to switch to auto pan
mode.
Zoom Click to zoom in/out.
Focus Click to adjust the focus.
Iris Click to adjust the iris setting.
Speed Click to adjust the speed.
Channel Select Click to select the channel of the PTZ
camera.
Exit Click to return to the previous page or exit.
Goto Preset
Point Click to go to a specific preset point.
Set Preset Point Click to set a specific preset points of a PTZ
camera.
Click to adjust the camera in a fixed point.
Note:
You can set up to 255 preset bits for the
DVR. However, the actual preset quantity
varies depending on the PTZ camera
performance.
Clear Click to delete the selected preset.
Save Click to save the settings and preset points.
Total Display the total of preset bit.
Start point Display the starting point cruised. The
system default point is “001”.
Stop point Click to set the stop time at each point.
Note:
To change the PTZ settings, see “4.4.3 PTZ Setup” on page 53 .