KGUARD Security SHA116.V2 - Manual (Page 52)

ENGLISH
Chapter 4: Using the DVR
52
DVR User’s Manual
Menu item Description
Buzzer Set the buzzer duration when motion is detected (Off/10 S/20 S/40 S/60 S).
To disable buzzer, select Off.
Output Select the alarm sound duration of the I/O alarm device (10S/20S/40S/60S) then check to
apply the setting to each alarm type.
E-mail Enable/Disable email alarm notification. If the function is enabled, the system will send
the alarm images to the specified email address. See
“Email Alarm Notifications” on page
53 .
Full Screen Enable/Disable screen notification. If this function is enabled and the alarm is triggered,
the corresponding channel will be displayed in full screen. Select the screen display
duration (1 S/3 S/5 S/7 S/10 S)
MD Alarm Select to enable motion detection alarm. When an object moves into the motion
detection area, the alarm will be triggered.
I/O Alarm Select to activate the I/O alarm device when the alarm is triggered.
HDD Loss Select to enable HDD loss alarm. When the hard disk drive is not detected due to HDD
damage or the power supply malfunctions, or HDD auto-overwrite is off, the alarm will
be triggered.
HDD Space Select to enable HDD space alarm. When the hard disk drive is full, the alarm will be
triggered.
Video Loss Select to enable Video loss alarm. When DVR cannot receive the video input signal due
to camera damage, cable damage, or the power supply malfunctions, the alarm will be
triggered.
Alarm Time Select the alarm duration (30S/1 Min/2 Min/5 Min).
Post-
Recording
Select the post-recording duration.
Pre-Record
time
Enable/Disable pre-recording before the alarm occurs.
8
After all settings are complete, click Apply.
9
When data saving is complete, click OK.
Note:
To ensure that motion detection alarm is properly working, you need to enable the motion detection function. See
“4.4.5 Setting Motion Detection” on page 55 .