Neuspeed 66.10.94 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com
SHORT SHIFT KIT – Manual Transmission
INSTALLATION INSTRUCTION
PART NUMBER: 66.10.94
APPLICATIONS:
2006.5-UP Audi A3 (8P), TT (8J) equipped with both 6-Speed Transmission and OEM shifter part #1K0 711 051 N
2006.5-08.5 VW GTI MKV, Jetta GLI MKV, EOS, Passat (B6) equipped with 6-Speed Transmission and OEM shifter part # 1K0 711 051 N
FOR: 2008.5-UP w/ 2.0 TSI (CCTA/CBFA) installation see other side
PART LIST: 1 – GEAR SELECTOR LEVER w/SMALL PIN STUD (.330” / 8.4 mm diameter)
TOOLS REQUIRED: 1 – 13mm SOCKET 1 – RATCHET HANDLE
1 – 6” OR LONGER EXTENSION 1 – TORQUE WRENCH
1. Remove clip on end of shifter cable and remove cable that attaches to gear selector lever.
2. Unbolt gear selector lever from selector shaft using a 13mm socket – remove lever (rock lever back and forth while pulling up).
3. Grease guide rail on NEUSPEED® gear selector lever. Install selector lever by first installing guide rail in white plastic guide. Then
match up splines on selector shaft – note wide alignment spline. Install lock nut and torque to 20 ft./lbs.
4.
Grease pin on gear selector lever and re-attach cable. Re-attach retaining clip.
5. Carefully double-check complete installation to be sure nothing interferes with the shift linkage, tightness of all nuts and bolts, and
check that ALL gears engage smoothly and fully BEFORE STARTING ENGINE OR TEST DRIVING!
©Copyright 2006, NEUSPEED ® . All rights reserved. Reproduction in whole or in part prohibited.
DOC.66.10.94 Rev. 4.26.10