Neuspeed 25.02.25.3 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com
25mm TUBULAR REAR ANTI-ROLL BAR
FITS: 2006-up AUDI A3(8P) FWD, 2008-09 AUDI TT(8J) FWD
2005-up VOLKSWAGEN GTI, GLI, SPORTWAGEN MKV/VI, Jetta V
2006-up Passat(B6) FWD, 2007-09 Rabbit
2009-up CC FWD, 2010-up Golf VI & 2011-12 Tiguan FWD
PART # 25.02.25.3
INSTALLATION INSTRUCTIONS
PARTS LIST:
1 – TUBULAR ANTI-ROLL BAR 1 – SILICONE GREASE
2 – POLYURETHANE BUSHINGS
TOOLS REQUIRED: 1 – RATCHET WRENCH
1 – M10 TRIPLE SQUARE (12 POINT) OR 8mm HEX KEY WRENCH
1 – M6 TRIPLE SQUARE (12 POINT) OR 5mm HEX KEY WRENCH
1 – 16mm WRENCH
1. Park car on a flat, level surface capable of supporting the vehicle’s weight on jack and
jack stands. Using the manufacturer’s recommended lifting point(s), raise rear of vehicle
and support with jack stands. NEVER WORK ON A VEHICLE SUPPORTED ONLY WITH
A JACK!
2. Disconnect end-links from original anti-
roll bar by securing stud with M6 Triple
Square or 5mm hex key wrench and
loosening nut with 16mm wrench.
3. Remove four bushing clamp mounting
bolts using a M10 Triple Square or 8mm hex
key wrench and remove original anti-roll bar
from vehicle.
4. Apply silicone grease to the inside of
supplied bushings and install on the inside
of stop washer on NEUSPEED anti-roll bar.
5. Install NEUSPEED anti-roll bar using
original clamps and bolts to sub-frame.
Torque bolts to 20Nm (15 ft-lbs).