Neuspeed 65.10.76 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com & http://www.apsoutlet.com
RACE SERIES COLD AIR INTAKE KIT
R32 – PART# 65.10.33 & 65.10.33P
GOLF IV & JETTA IV 2.0L 8V/1.8t / VR6 12V w/AIR PUMP - PART# 65.10.76 & 65.10.76P
GOLF IV & JETTA IV VR6 24V w/o AIR PUMP – PART# 65.10.77 & 65.10.77P
GOLF IV & JETTA IV w/o AIR PUMP 2.0L 8V – 65.10.78 & 65.10.78P
INSTALLATION INSTRUCTIONS (AIR PUMP KIT SHOWN)
PART LIST: 1 – COLD AIR INTAKE TUBE 1 – FILTER
1 – REDUCER HOSE FOR 2.0L & 1.8t 1 – RUBBER ISOLATOR
1 – STRAIGHT HOSE FOR VR6 1 – M6 FLAT WASHER
3 – M6 NYLON LOCK NUT 2 – HOSE CLAMPS
1 – ¼” RUBBER GROMMET
TOOLS REQ: 1 – RATCHET 1 – 12” EXTENSION
1 – 10MM SOCKET 1 – 10MM WRENCH
1 – STANDARD SCREWDRIVER 1 – PUNCH
1 – PHILLIPS SCREWDRIVER 1 – HAMMER
1 – NEEDLE NOSE PLIERS
WARNING : THIS KIT IS DESIGNED FOR DRY WEATHER USE ONLY. ENGINE DAMAGE MAY
OCCUR IF USED IN WET WEATHER CONDITIONS. IF YOU ANTICIPATE DRIVING IN WET
CONDITIONS, REMOVE THIS KIT AND RE-INSTALL THE FACTORY SYSTEM
1. Remove entire factory air box by disconnecting
Mass Air Flow meter (MAF) electrical connector,
air pump connection (if applicable), and two (2)
10mm hex mounting bolts that hold air box to
vehicle. Release MAF from rubber intake hose by
squeezing spring clamp with needle nose pliers.
2. Remove battery box by removing one (1) bolt
(10mm hex). Pull straight up to remove.
3. Remove side air duct by removing one (1) nut
(10mm hex).
4. Remove four (4) Phillips screws securing upper
air duct to core support and lift out.