Neuspeed 65.10.87 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com & http://www.apsoutlet.com
P-FLO KIT FOR AUDI TT(8N) 180HP / VW BEETLE 1.8T
GOLF IV & JETTA IV 1.8T / 2.0L
PART # 65.10.72 & 65.10.87
INSTALLATION INSTRUCTIONS
PARTS LIST:
1 – P-FLO SS AIR BOX 2 – ¼”x20x 5 /
8
” HEX BOLTS
1 – NEUSPEED AIR FILTER 2 – ¼”x20 NYLOC NUTS
2 – M6 ACORN NUTS 2 – RUBBER MOUNTS
TOOLS REQUIRED: 1 – SCREW DRIVER 1 – 7 /
16
” SOCKET
1 – 10mm SOCKET 1 – 7 /
16
” WRENCH
1 – PLIERS 1 – 6” OR LONGER SOCKET EXTENSION
Features of the NEUSPEED
®
Stainless Steel P-Flo air intake system, is that stainless steel reflects heat away from
the air filter, and along with its hi-tech looks, it will never rust.
1. Unplug Mass Air Flow (MAF) sensor wire. Squeeze spring clamp or loosen hose clamp that holds the air intake
hose to the MAF sensor, and pull hose off MAF.
2. Remove the two screws on back side of air filter housing and lift off top cover. Then remove the two bolts
(10mm) located at front and back of lower portion of air filter housing and remove.
3. Remove MAF (two screws) from top cover. Using supplied bolts and nyloc nuts ( 7 /
16
”), attach the MAF to the
engine side of P-Flo bracket with the electrical connector facing toward the rear.
4. Hand-tighten supplied rubber mounts into original air box mounting holes on vehicle.
5. Install completed assembly onto studs on rubber mounts using the acorn nuts supplied. NOTE: Use tape in socket
to hold acorn nut when installing. Re-clamp the air intake hose to the MAF sensor; connect MAF sensor wire into
harness.
6. Install NEUSPEED air filter. Be sure to recheck filter clamp for tightness a week later.
7. Carefully double-check complete installation. TEST DRIVE CAREFULLY!
©Copyright 2005, NEUSPEED ® . All rights reserved. Reproduction in whole or in part prohibited.
DOC.65.10.72&87 Rev. 04.15.05