Neuspeed 62.10.92 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
POWER PULLEY KIT
2008.5-UP AUDI A3, TT 2.0 TSI
2008.5-UP VW Golf V & VI, 2008.5-2013.5 Jetta V & VI, Passat/CC, EOS, Tiguan 2.0 TSI 200HP/1.8 TSI
PART # 62.10.92
INSTALLATION INSTRUCTIONS
PART LIST: 1 – CRANKSHAFT PULLEY 1 – BELT
1 – CRANKSHAFT BOLT
TOOLS REQUIRED: 1 – 17mm Wrench 1 – Ratchet Wrench
1 – T25 Torx 1 – VW Tool T10355 Counter Holder
1 – T30 Torx 1 – Torque Wrench
1 – 24mm Socket 1 – Long Handle Breaker Bar
NOTE: FACTORY TOOL REQUIRED AND PROFESSIONAL INSTALLATION RECOMMENDED.
1. Car Hoist required, vehicle not high enough from
ground with a jack or jack stands.
2. Remove lower engine splash guard and
passenger side plastic lower inner fender liner
(T25 Torx) to expose crankshaft pulley.
3. Pull-out clip to release rubber intercooler hose
from turbo discharge plastic pipe.
4. Unbolt turbo discharge plastic pipe from engine
just below crankshaft pulley, (2) T30 Torx.
5. Pull-out clip to release upper rubber hose from
turbo, and then remove turbo discharge pipe.
6. Remove discharge pipe mounting bracket from
engine using T30 Torx.
7. Before removing ribbed belt, mark running
direction with marking pen if the stock belt and
pulley is ever to be re-installed.
8. Using a 17mm wrench, rotate idler pulley center
bolt upwards to release tension and remove
ribbed belt. Now slowly release belt tensioner.