RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 12)

COPYRIGHT © 2014 RED.COM, INC
RED 3-AXIS SYSTEM OPERATION GUIDE
955-0044, REV-D | 12
E. Tighten the thumbscrew until hand tight.
WARNING: DO NOT OVERTIGHTEN.
2. Install the RED Lens Control Motor Mounting Bracket.
A. Push the lock button on the Lens Control Motor Mounting Bracket to disengage the locking mechanism.
B. Slide the dove-tail rail on the Lens Control Motor Mounting Bracket into the dove-tail slot on the
Lens Control Motor.
C. Release the lock button.
D. Tighten the M4 thumbscrew on the side of the Lens Control Motor Mounting Bracket to lock the bracket
in place.
3. Mount the Lens Control Motors to the support rods.
A. If you are using 15mm support rods, install the 19mm-to-15mm Reducer Bushings into the clamp.
B. Position the Lens Control Motors at the desired position on the support rods.
C. Use the thumbscrew to tighten the clamp on the Lens Control Motor Mounting Bracket.
NOTE: For more information, go to “Lens Control Motor” on page 41 .
Mount
Lens Control Motors