RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 45)

COPYRIGHT © 2014 RED.COM, INC
RED 3-AXIS SYSTEM OPERATION GUIDE
955-0044, REV-D | 45
06
All RED products are designed for rugged durability, but precision instruments demand proper care. Please take
note the special care guidelines in this section.
WARNING: DO NOT attempt to modify, dismantle or open the Lens Control Motor, Tactical Hand Controller
(T.H.C.), Wireless Motor Driver (W.M.D.), or other accessory as doing so may expose you to electric shock and
serious injury. There are no user-serviceable parts inside. Alteration or repairs made to the Lens Control Motor,
T.H.C., W.M.D., or other accessory, except by a RED authorized service facility, will void the Limited Warranty.
CLEAN 3-AXIS SYSTEM COMPONENTS
Clean ONLY using a dry cloth. When cleaning your Lens Control Motor, T.H.C., W.M.D., or other accessory,
remember that the components are not waterproof and moisture can damage electronic circuitry.
WARNING: DO NOT rinse or immerse any part of the Lens Control Motor, T.H.C., W.M.D., or other accessory.
Keep components dry at all times.
WARNING: DO NOT use soaps, detergents, ammonia, acetone, alkaline cleaners, abrasive cleaning compounds,
or solvents. These substances may damage electronic circuitry.
NOTE: Using any fastener or adhesive material may leave residue on equipment. If residue is left behind, use an
appropriate isopropyl alcohol cleaner and a lint-free cloth to clean. Apply a small amount of cleaning solution
to the lint-free cloth and wipe.
STORE THE 3-AXIS SYSTEM
It is important to properly store and protect your equipment when it is not in use. Use the following tips when
storing components of the RED 3-Axis Lens Control System:

Remove the detachable antenna from the T.H.C. and W.M.D. to prevent accidental damage to the antenna
and antenna connector.

Remove the battery from the T.H.C. When the battery is removed, ensure that dirt, dust, or other debris
does not get into the battery bay or the microSD slot.
SYSTEM
MAINTENANCE