RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 65)

RED 3-AXIS SYSTEM OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0044, REV-D | 65
RED CAN COMMAND CABLE (5', 50', 100')
The RED CAN Command Cable is a 4-pin 0B to 4-pin 0B LEMO cable that provides CAN communications and
power from the W.M.D. to the T.H.C. It is used for wired operation and wireless pairing of T.H.C. units.
W.M.D. CAN T.H.C. CAN
FGG-0B.304.CLAD52Z FGG-0B.304.CLAD52Z
PIN SIGNAL WIRING PIN SIGNAL
1 GND 1-1 1 GND
2 CANL 2-2 2 CANL
3 CANH 3-3 3 CANH
4 VCC 4-4 4 VCC
REDLINK-TO-T.H.C. CONNECTOR CABLE (3')
The REDLINK™-to-T.H.C. Connector Cable (3') is a 6-pin 0B to 6-pin 0B LEMO cable that enables you to pair
the RED T.H.C. (Tactical Hand Controller) to your REDLINK Bridge to control the iris and focus of motorized
Canon and Nikon lenses.
REDLINK AUX T.H.C. AUX
FGG-0B.306.CLAD56Z FGG-0B.306.CLAD56Z
PIN SIGNAL WIRING PIN SIGNAL
1 GND 1-1 1 GND
2 Rx 2-3 2 Tx
3 Tx 3-2 3 Rx
RED CAN Command Cable (5')
REDLINK-to-T.H.C. Connector Cable
(3')